Syringe Filter 13mm (PTFE) 0.2µm non sterile Pack of 100

£159.11 excl. VAT
£190.93
incl. VAT

SKU - 1173444

SF13PT22C

SKU -

1173444

3 In Stock

A range of economical, disposable and extremely easy to use PTFE syringe filters. Designed with female luer lock inlet and male luer slip outlets.
Sterile filters are RNase, DNase, DNA and pyrogen free and are individually wrapped. Packs of 1000 filters are packaged in clear bags.

Applications

Broad Chemical Compatibility
Strong chemical compatibility and inertia
Filtration of air and gases
Preparation of HPLC or GC samples

Properties

Porosity	0.2µm	0.45µm
Membrane type	Hydrophobic	Hydrophoboc
Water Flow	17-23 ml/min/cm³	30-43 ml/min/cm³
Bubble point*	120kPa	80kPa
Applicable pH range	pH 1-14	pH 1-14
Maximum operating temperatue	Up to 130ºC	Up to 130ºC
Chemical resistance	Most organic solvents and alkaline liquids	Most organic solvents and alkaline liquids

*Bubble point: pressure required for a liquid to flow through a dry filter membrane. For liquid to flow through the membrane the bubble point pressure must be overcome. If bubble point pressure cannot be attained with a certain combination of liquid, filter membrane and vacuum increasing the pore size is a solution.

Guide to…Syringe Filter Properties

Identifying the filter material most suitable for your application based upon the nature of the liquid or gas you are filtering will ensure the best performance of your filter. Each syringe filter contains a membrane filter of a set diameter and plastic housing with luer connections used for connecting to syringes (or in-line hosing systems).

The membrane filter material has differing chemical and physical properties such as hydrophobicity, flow rate, extractables and protein retention making them suited to differing applications. Once you have selected the most compatible filter material, you will need to consider what pore size is most appropriate for your application and what diameter filter is suitable for your sample volume.

Membrane Material

Membrane Material	Protein binding	Hydrophilic/Hydrophobic	Chemical resistance	Applications
Hydrophilic PTFE	Low	Hydrophilic	High	Purification of HPLC organic and solvent/aqueous solutions
Hydrophobic PTFE	Low	Hydrophobic	High	Filtration of solvents
PES	Low	Hydrophilic	Low/Medium	Purification of tissue culture solutions, buffers
PVDF	Low	Hydrophilic	Medium	Filtration of protein solutions
NYL	Medium	Hydrophilic	Medium	Filtration of aqueous and solvent/aqueous mixtures
CA	Low	Hydrophilic	Low	Filtration of protein solutions
CN	High	Hydrophilic	Low	Filtration of aqueous solutions where protein binding is not a concern and microbioloigical applications.
RC	Low	Hydrophilic	Medium	Filtration of aqueous and organic solvents and protein recovery applications.

Filter diameter

High particulate loaded samples with tend to block the pores in the membrane more quickly so the total volume you can filter through a certain diameter syringe filter will vary greatly. Please take the below figures as a guide only.

13mm diameter - for samples <10ml
25mm diameter - for samples <100ml
33mm diameter - for samples <250ml

For samples that are very particle ladden, it is recommened that you try pre-filtering your sample. Pre-filtering can be achieved with a number of different filters, such as glass microfibre. Some syringe filters come with an in-built pre-filter.