The methods
The MINIKITs are designed for tablet based rapid water testing. Most MINIKITS are based on titrimetric methods.
Tablet count method
In the tablet count method, the liquid titration solution and indicator are replaced by Lovibond tablet reagents. A specific number of tablets is added to a defined sample volume until a hemically induced colour change takesplace. The concentration of the parameter being measured is calculated from the number of tablets required. The measuring range can be expanded by varying the sample volume.
Speed test
The speed test is based on reverse titration. After adding a reagent tablet to a calibrated test
tube, the water sample is added slowly until the colour of the solution changes (e.g. from red to
blue). The user can then obtain the result from the liquid level.
Yes/No test
A Yes/No test tells the user whether a specific ingredient is present in the water and/or if its
concentration is higher or lower than a defined level.
Turbidity method
A two-section calibrated test tube is filled with the water sample and a reagent tablet added.
The reagent creates a level of turbidity that is proportional to the concentration of the parameter being measured. The inner tube, which has a black dot on its base, is lowered until the dot is obscured by the turbidity. The result is read off from the water level in the inner tube.
An important point to note apart from the table below please consult.
Parameter | Â | UK Recommended Levels |
Bromine | Â |
4-6 mg/L |
Calcium Hardness | Â |
80 – 200 mg/L |
Chlorine (Free and Total) |  |
|
Cyanuric Acid | Â |
|
pH | Â |
|
Phosphate |  | 0.01 mg/L or below. |
Total Alkalinity |  | 80 – 200 mg/L CaCO3 |
Turbidity |  | 0.5 NTU (Nephelometric Turbidity Units) |
Parameter | Â | UK Recommended Levels |
Chlorine | Â | 1.0 mg/L |
Bromine | Â | 4-6 mg/L |
PHMB | Â | 20-40 mg/L |
Hydrogen Peroxide | Â | 30-100 mg/L |
Ozone | Â | 1 mg/L for two minutes |
pH | Â | 7.2-7.4 ideally, 7.0-7.6 is acceptable |
Alkalinity | Â | Between 80-200 mg/L |
Cyanuric Acid | Â | 25-50 mg/L |
Calcium Hardness | Â | Below 80-200 mg/L |
Phosphate | Â | Below 0.01 mg/L |
TDS | Â | Not more than 1000 mg/L above mains water, to a maximum of 3000 mg/L |
Salinity | Â | Between 2500-3500 mg/L |
Turbidity | Â | Less than 0.5 NTU |
Colony Count | Â | Not more than 10 CFU per 100 mL |
Total Coliforms | Â | Absent in 100 mL |
E. coli |  | Absent in 100 mL |
Ps. Aeruginosa | Â | Absent in 100 mL |
Products in this Range